Job Listing

Schedule and Pay:

• HOURS: Monday-Friday, 1st Shift (6:30am-2:30pm)
• PAY: $16/hour
• Possible Temp to Perm
• LOCATION: Beacon, NY
• Background and Drug Screen REQUIRED

‍Responsibilities Include:

• Runs one or more automatic compression molding presses at a time.
• Uses previously prepared “pre-forms” or “make readies” composed of plastic sheet, calendered rubber, coated or cemented fabric, etc. as raw materials or may assemble various materials into pre-forms before loading cavities.
• Places “pre-forms” into loading fixture and transfers them to mold cavities from fixture, sheet loads multiple cavities, or hand loads “make-ups” into mold cavities.
• One set of loading frames may be used alternately by operators based upon availability and compatibility with job being run.
• Removes molded parts from press and places them on table to cool, or on special cooling fixtures.
• Cleans and lubricates mold cavities as instructed or as required.
• Loads mold cavity, closes press and starts cure cycle.
• During the cure cycle dust the part, remove flash, divide sheet, and/or visually inspect the molded part.
• Spot check parts during cure cycle and report any abnormal appearance to supervisor for quality concerns.
• Follows safety practices and maintains good housekeeping.
• Reports any unsafe conditions found in the plant.
• Fills out requisitions and report forms in accordance with company policy and procedure.
• Performs all duties as assigned by manager, supervisor and/or group leader.
• Has the ability to take own initiative to fully utilize time.

Education, Knowledge and Skill Requirements:

• High school diploma or equivalency diploma.
• Must be able to read and write English.
• Able to identify parts that do not meet quality requirements using appropriate tools.
• Able to work as part of a team or independently as required.

‍